Hide Table of Contents

Defining Collinear Geometric Constraints

Use the GcColineal command to make Lines and linear PolyLine segments collinear.

You can specify multiple linear PolyLine segments of one and the same PolyLine to make them collinear.

To define collinear Geometric Constraints:

  1. Click Constraints > Geometric Constraints > Collinear (or type GcCollinear).
  2. Specify the first entity (Line or linear PolyLine segment).
  3. - or -
  4. Specify Multiple, then specify the first entity.
  5. Specify the second entity (Line or linear PolyLine segment).
  6. If you use the Multiple option, specify other linear entities to make collinear to the first entity.
  7. Press Enter.
  8. The second and following entities are collinear to the first entity.

Access

Command: GcCollinear

Menu: Constraints > Geometric Constraints > Collinear

Parent Topic

Applying Geometric Constraints



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Defining Collinear Geometric Constraints
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2022 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46