Hide Table of Contents

Creating Vertical Linear Dimensions

The VerticalDimension command lets you create vertical linear dimensions. The vertical distance between the defining points is measured and the dimension line is parallel to the Y-axis.

To create vertical linear dimensions:

  1. Type VerticalDimension at the command prompt.
  2. In the graphics area, specify the first and second extension line origins.

    - or -

    Press Enter, then select an entity to dimension. You can specify Lines, PolyLines, Circles, and Arcs. The start and end points of linear entities, or the diameter of circular entities are measured.

  3. Specify the position of the dimension line or specify an option:

    Angle, Note, or Text: See Editing and Formatting Dimension Text.

    The measurement is placed as dimension text based on the definitions of the current DimensionStyle.

  To dimension the real length of lines not parallel to the X- or Y-axis of the coordinate system, use the ParallelDimension command.

Access

Command: VerticalDimension

Related Topics

Creating Linear Dimensions

Creating Horizontal Linear Dimensions

Creating Rotated Linear Dimensions

Creating Parallel Dimensions



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Creating Vertical Linear Dimensions
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2022 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46