Hide Table of Contents

Replacing the Current Drawing with a Selected One

Use the ReplaceOpen command to close the current drawing and open a selected one.

If the current drawing has not been saved, the command asks you to save it.

To open a drawing with a selected one:

  1. Type ReplaceOpen.
  2. To specify whether you want to save the changes in the current drawing, type Yes or No.
  3. Specify the drawing to open and click Open.

Access

Command: ReplaceOpen

Related Topics

Opening a Drawing

Opening a Drawing at the Command Prompt

Saving a Drawing

Closing a Drawing



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Replacing the Current Drawing with a Selected One
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2022 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.21