Hide Table of Contents
SetFlipOffsetDirAtEnd2 Method (ICWLinkageRod)

Sets the flip direction of the offset at End 2 of this linkage rod connector.

.NET Syntax

Visual Basic (Declaration) 
Sub SetFlipOffsetDirAtEnd2( _
   ByVal NFlipDir As System.Integer _
)
Visual Basic (Usage) 
Dim instance As ICWLinkageRod
Dim NFlipDir As System.Integer
 
instance.SetFlipOffsetDirAtEnd2(NFlipDir)
C# 
void SetFlipOffsetDirAtEnd2( 
   System.int NFlipDir
)
C++/CLI 
void SetFlipOffsetDirAtEnd2( 
&   System.int NFlipDir
)

Parameters

NFlipDir
Offset flip direction as defined by swsFlipOffsetDir_e

Remarks

This method is not valid if End 2 is a vertex.
 

See Also

Availability

SOLIDWORKS Simulation API 2022 SP0


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   SetFlipOffsetDirAtEnd2 Method (ICWLinkageRod)
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: API Help (English only) 2022 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46