Hide Table of Contents

Modify terminal numbers

Contextual menu of a symbol: Edit symbol terminals

Component properties > Manufacturer part and circuits > Contextual menu of a circuit: Edit terminals

PLC management > Contextual menu of a channel : Edit terminals

 

Circuit: Indicates the circuit number.

Index: Indicates the order number in the circuit.

Mark: Used to enter the number of the material terminal. By default, the number of the material terminal is provided by the manufacturer part associated with the component.

Orientation: Allows you to specify the orientation of the connection point, specifically for the terminals.

Wire termination type: Allows you to select or to change the termination type associated to the component terminal.

Max wire number: Used to enter the number of wires or cable cores that can be connected to the material terminal.

Mnemonic: Used to enter a channel mnemonic (PLCs).

Utilization: Allows you to enter free text. This can be propagated in a specific attribute of the connection point.

Maximum wire section (mm²) / Minimum wire section (mm²): Used to enter the section on the terminal device.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Modify terminal numbers
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS Electrical 2022 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.21