Hide Table of Contents

Managing the Insertion point

For a symbol, the insertion point corresponds to a fictitious point used for insertion into the scheme. Generally, it corresponds to a connection point with a wire.

 

For a title block, the insertion point corresponds to the bottom left-hand corner of the title block. In general, to ensure data integrity (position of the cross references and origin-destinations polarity), we advise you to place the title block insertion point at coordinates "0,0".

 

The Insertion point feature can be also used in the specific macros used in XLS Automation.

 

Menu: Edit symbol > Insertion point (Symbols)

Menu: Edit title block > Insertion point (Title blocks)

 

Click a point corresponding to the insertion point in the graphical interface. An oblique red cross represents this point.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Managing the Insertion point
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS Electrical 2022 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.21