Hide Table of Contents

Setting Z-Plane and Thickness

Use the ZPlane command to set the elevation plane and thickness for new drawing entities:

  • ZPlane: Specifies the Z-coordinate for new entities in the current coordinate system when you enter XY-values for points. Usually, nonzero elevations act as temporary construction planes.
  • Thickness: Gives drawing entities height which makes them appear as 3D surfaces. Thickness is the distance the entity extrudes above or below its base elevation. A positive value extrudes upward. A negative value extrudes downward. A value of 0 applies no thickness.

You can apply thickness to these drawing entities:

  • Lines
  • Arcs
  • Circles
  • PolyLines
  • 2D Solids
  • Traces
  • Text

You cannot apply thickness to these entities:

  • Hatches
  • Dimensions
  • Ellipses
  • Splines
  • Regions

To define the Z-plane and thickness for new drawing entities:

  1. Type ZPlane at the command prompt.
  2. Specify an elevation for all new drawing entities.
  3. Specify a thickness for new drawing entities.

    The setting applies only to drawing entities that can have thickness.

To modify the thickness of drawing entities:

Access

Command: ZPlane



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Setting Z-Plane and Thickness
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2023 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.