Hide Table of Contents

Terminating Component Editing

The CloseComponent command ends the in-place editing of a Block definition or Reference initiated by the EditComponent command.

To end in-place editing of a Block definition or Reference:

  1. Click Modify > Component > Close (or type CloseComponent at the command prompt).
  2. In the Component dialog box, click Save to save the changes of the Block definition or Reference you have edited

    - or -

    Click Discard to end Component editing without saving the changes.

  Use SaveComponent to save the changes and end the Component editing session.


Command: CloseComponent

Menu: Modify > Component > Close

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Terminating Component Editing
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: 2023 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.