Hide Table of Contents

Creating 4-Point Angular Dimensions

Use the 4PointAngleDimension command to create an angular Dimension based on two points each on the two legs of an angle.

The command lets you create the Dimension of the interior angle between the two legs and the exterior angle.

To create four-point angular Dimensions:

  1. Type 4PointAngleDimension at the command prompt.
  2. In the graphics area:
    1. Select two points to define the first line.
    2. Select two other points to define the second line.
    3. Specify the position of the dimension arc lines or specify an option:

      Angle, Note, or Text: See Editing and Formatting Dimension Text.

      The position determines whether the inner or outer angle is measured.

  Use EntitySnaps to define the two legs on entities.

Access

Command: 4PointAngleDimension



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Creating 4-Point Angular Dimensions
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2023 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.