Hide Table of Contents

Creating Geometric Tolerances

Use the Tolerance command to create and place datum indicators and basic Dimension notations in the drawing.

Following is an example of a Tolerance:

The following tables describe the Tolerance and material condition symbols you can select in the Geometric Tolerance dialog box.

Geometric characteristic symbols

Symbol Characteristic Type
Position Location
Concentricity or coaxiality Location
Symmetry Location
Parallelism Orientation
Perpendicularity Orientation
Angularity Orientation
Cylindricity Form
Flatness Form
Circularity or roundness Form
Straightness Form
Profile of a surface Profile
Profile of a line Profile
Circular runout Runout
Total runout Runout

Material condition symbols

Symbol Definition Type
At maximum material condition, a feature contains the maximum amount of material stated in the limits. MMC
At least material condition, a feature contains the minimum amount of material stated in the limits. LMC
Regardless of feature size, indicates that the feature can be any size within the stated limits. RFS

To create a Tolerance:

  1. Click Dimension > Tolerance (or type Tolerance).
  2. In the dialog box, from corresponding lists select symbols for geometric characteristics and material condition (M.C.) specifications. Select Diameter to turn on diameter symbols.
  3. Complete the specifications by typing tolerance values in the corresponding text boxes.
  4. Enter datum values as necessary and select appropriate material condition symbols.
  5. Enter a Datum identifier.
  6. Enter a Height for the Tolerance.
  7. Add the Projected tolerance zone symbol if necessary.
  8. Click OK.
  9. In the graphics area, specify the position of the Tolerance.

    The Tolerance displays in the graphics area.

Access

Command: Tolerance

Menu: Dimension > Tolerance



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Creating Geometric Tolerances
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2023 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.