Using Display States

You can change the display settings of the components and save the settings in a display state.

At the top of the FeatureManager design tree, to the right of the tabs, click Show Display Pane .
The Display Pane shows the different display settings (appearances, transparency, etc.) of each component.
Right-click anywhere in the Display Pane and click Add Display State .
Enter a name and press Enter.
Move the pointer over Tutor2 in the FeatureManager design tree, then:
1. Move the pointer into the Display Mode column.
2. When the pointer changes to , click, then select Hidden Lines Visible .
Click Hide Display Pane .
Right-click and click Display State-1.
The assembly returns to its original display state.

Congratulations! You have completed this tutorial.

Search 'Using Display States' in the SOLIDWORKS Knowledge Base.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required


*Email:
Subject:		Feedback on Help Topics
Page:		Using Display States
*Comment:
*		I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Cancel

Print Topic

Select the scope of content to print:

This topic and all topics linked from this topic
Just this topic
This topic and only immediate topics under it
This selected topic and all subtopics

Cancel

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

Never show this message again

Web Help Content Version: SOLIDWORKS Connected Tutorials (3DEXPERIENCE SOLIDWORKS) 2023 SP04

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.