Hide Table of Contents

Number wires

Every wire that you draw in a schematic can have numbering applied to it. A mark is applied to it that lets you manage and optimize installation cabling. This numbering is optional, and you can choose to number only certain sets of wire types.

You can also have two numbering modes: an equipotential numbering mode (all wires connected on the same potential), and a wire numbering mode (physical wires connecting the components).

Wire numbering follows a simple rule: the numbering starts in the first drawing and continues through the drawings, based on their order as displayed in the dockable panel. In the drawing, the actual position of the wires is also taken into account. The numbering starts in the upper left and increases toward the lower-right hand side.

Numbering parameters are defined in the Wire type management and the electrical project configuration. You can start numbering your wires at any time during electrical project development. You can also manually apply wire numbering, or modify any previously-numbered wire.

 

 



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Number wires
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS Electrical 2023 SP0

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.