Hide Table of Contents

Renumber marks

If modifications are made to the mark settings in the electrical project configuration, the marks for existing elements in the electrical project must be updated (Such as components or locations).

 

Menu: Process > Renumber marks

Selection

Whole project: Handles all of the electrical project elements.

Current book: Handles only elements contained in the current book (book associated with the current scheme).

Renumbering mode

Update marks: Lets you renumber the elements selected in the list in the Elements section, after modification of the marking formula. The order number is maintained and the manual marks are also maintained.

Recalculate order numbers: Lets you renumber the elements selected in the list in the Elements section. The order numbers are recalculated in relation to their position in the drawings and if you check Recalculate manual marks, the manual marks are also renumbered.

Elements

Check the boxes for the elements to be processed by the renumbering command.

 

Click the Mark configuration... button to access the mark settings.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Renumber marks
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS Electrical 2023 SP0

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.