The absolute value of the variable specifies the size, in drawing units, of the center mark, which is half the length of the center mark. This is also the length of the portion of a centerline beyond the arc or circle, as well as the length of the gap between the center mark and centerlines.

The sign of the variable controls the center marks and centerlines as follows:

Positive values determine that center marks are drawn.
Negative values determine that centerlines are drawn.
A zero value determines that no center marks or centerlines are drawn.

Properties

Type	Real
Default	0.09
Status	Read / Write
Saved	In the drawing

Related Commands

CenterMark, RadiusDimension, DiameterDimension

Search 'SetRDmCM' in the SOLIDWORKS Knowledge Base.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required


*Email:
Subject:		Feedback on Help Topics
Page:		SetRDmCM
*Comment:
*		I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Cancel

Print Topic

Select the scope of content to print:

This topic and all topics linked from this topic

Just this topic

This topic and only immediate topics under it

This selected topic and all subtopics

Cancel

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

Never show this message again

Web Help Content Version: 2023 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.