Hide Table of Contents

Adding Entities to a Visibility State

Use the CBShow command to specify the entities to display in a visibility state.

To add entities to a visibility state:

  1. In the Block Editor, specify the active visibility state.
  2. Type CBShow at the command prompt.

    The entities visible in the active visible state are highlighted.

  3. In the graphics area, specify the entities to display.
  4. Press Enter.

Access

Command: CBShow

Related Topics

About Visibility States

Managing Visibility States

Parent Topic

Controlling Visibility of CustomBlocks Entities



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Adding Entities to a Visibility State
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2023 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46