Hide Table of Contents

Zooming

The Zoom commands change the magnification of the drawing display. The ratio of the entire drawing to the entities affected by zooming remains unchanged.

Zoom commands are on the View menu or the Zoom toolbar:

  • Zoom Dynamic : Zooms in and out of the current drawing window at realtime
  • Zoom Center : Centers the drawing on a center point using a specified magnification factor or a display height
  • Zoom Factor : Zooms in or out using a scale factor you specify
  • Zoom Previous : Restores the previously displayed view
  • Zoom Selected : Zooms so that one or more entities are entirely on screen
  • Zoom Window : Zooms in to a rectangle you specify
  • Zoom In : Zooms in using a preset scale
  • Zoom Out : Zooms out using a preset scale
  • Zoom Bounds : Displays the entire drawing as far as its drawing bounds or drawing extents (whichever dimension is greater)
  • Zoom Fit : Zooms to display the whole drawing centered on the screen

Transparent Use of Zoom Commands

You can use zoom commands while another command is in progress. For example, you can execute the ZoomFit command while drawing a Line:

: LINE
Specify start point» <P1>
Specify next point» <P2>
Specify next point» 'zoomfit
Resuming line command.
Specify next point» <P3>
Specify next point» <P4>
...

Related Topics

Dynamic Zoom

Panning



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Zooming
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2023 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.