Hide Table of Contents

Updating the Style Settings of Annotative Entities

Use the AnnUpdate command to update existing annotative entities (Notes, SimpleNotes, BlockAttributes, Dimensions, and Tolerances) to match updated TextStyle or DimensionStyle settings.

To update the style settings of annotative entities:

  1. Click Modify > Annotation Scaling > Update Annotation Style Settings (or type AnnUpdate).
  2. In the graphics area, specify annotative entities.
  3. Press Enter.

    The annotative entities are updated and use the current style settings.

  Note: You can use the AnnUpdate command only on the Model tab or in the Model workspaces on layout Sheets.


Command: AnnUpdate

Menu: Modify > Annotation Scaling > Update Annotation Style Settings

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Updating the Style Settings of Annotative Entities
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: 2023 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.