Hide Table of Contents

Creating Ruled Meshes

The RuledMesh command creates a ruled surface between two boundary curves (profiles). The resulting surface is a PolygonMesh.

To create ruled surfaces:

  1. Click Draw > Mesh > Ruled (or type RuledMesh).
  2. In the graphics area, select an entity (first defining curve) to define the surface edges. Valid entities include points, Lines, Arcs, Circles, and 2D or 3D PolyLines.
  3. Select an entity (second defining curve) for the boundary outline.

    If the entity for the first defining curve is:

    • An open entity (such as an Arc or Line), the second entity must be an open entity
    • A closed entity (such as a Circle or a closed PolyLine), the second entity must be a closed entity
    • A point, the second entity cannot be a point

  To create a PolygonMesh, select each entity at the same end. If you select each outline entity at opposite ends, you generate a self-intersecting PolygonMesh.

Access

Command: RuledMesh

Menu: Draw > Mesh > Ruled



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Creating Ruled Meshes
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2023 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.