Projected View

Projected views are created by folding off an existing view in one of eight possible projections. The resulting view orientation is affected by the setting of First angle or Third angle projection as defined in the drawing sheet properties.

Projected views are created for orthogonal views with the following tools:

	Standard 3 View	The Front view is a model view and the other two views are projected views, using First angle or Third angle projection as specified in Sheet Properties.
	Model View	When inserting an orthographic (front, right, left, top, bottom, and back) model view, the Projected View PropertyManager appears so you can insert projected views from any orthographic views on the drawing sheet.
	Projected View	Insert projected views from any orthographic view.

You can create a projected view of an exploded assembly view, but not from a detail view.

Projected view from a projected view

Projected view from a section view - the entire part is shown