Each drawing is associated with a function when the drawing is created.
By default, the function is associated with the book. You can change the function for
drawings.
-
Do one of the following:
- Right-click a drawing and click Change
function.
- In Drawing properties, click
Function
.
The function selection dialog box opens.
-
Select a new function.
The components initially associated with the drawing's
original function are associated with the new function.
-
In the dialog box, specify the following options:
| |
|
| Change component function
|
Components with the same function as the drawing are
automatically associated with the new function. If the
component was drawn on several drawings, all symbols
representing the component are associated with the new
function (even if the drawings are not affected by the
change of function). For terminal strips, only the
function of the terminals is changed. The terminal
strips are attached to remain in their initial
function.
|
| Change drawing function
only |
The drawing itself is associated with the new function,
and no changes are made to the content of the
drawing. |
| Cancel |
Cancels the current command. No changes are made to the
drawing or its content. |