Hide Table of Contents

Animation

The Animation page lets you configure animation speed and the maximum frames between two images.

Command NameDescription
Animation speedSpecifies the rate at which animation images are displayed in frames per second (FPS). The animation frame rate is a property of the document. For example, if an animation defines 2 keys at 0 and 90. and the animation is played at 30 FPS, the duration of the animation is 3 sec.
Note: The animation speed for the National Television System Committee standard (NTSC) is 30 FPS. The animation speed for Phase Alternating Line (PAL) is 25 FPS.
Inter frames min.Specifies the minimum number of frames between two images. Depending on the graphics card and computer performance, animations might jump due to animation speed. Defining a minimum frame number between two images can eliminate jumping. Note that animation speed might not be respected.
Animated transitionSpecifies the transition speed between two views when you drag views into the viewport.
Max. objectsSpecifies the maximum number of nodes allowed for animated transitions between views. A node is any atomic unit of a document (property, actor, assembly group, etc.) Larger values can result in choppy transitions. For large models or for computers with limited RAM, reduce this value to improve performance.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Animation
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS Composer 2024 SP02

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.