Hide Table of Contents

Project

The Project page lets you configure the default preferences when loading a project.

This page discusses:

Geometry

This section lets you configure geometry-related preferences when loading a project.

Note: Sync does not support Geometry settings because they are stored in project (.smgProj) files.

Command Name Description
Load Loads the assembly-tree structure and geometry for products ( .smgProj and .smgXml files). When this option is cleared, only the tree structure is loaded. To reduce memory usage, clear this option for large models or when working with only a portion of a model.
Visible actors only Loads geometry for visible actors only.
Show only first level assembly tree (Available when Load is cleared.) Loads the root and first-level tree structure only (not sub-products or geometry).

Note: When you double-click an assembly or a part node in fully shattered structures (i.e. when you click the red icon that identifies it), only one level is loaded. To load all levels, right-click and click Product > Load Products or in the ribbon click Home > Visibility > Visibility > Load on Visibility.

When this option is cleared, the entire assembly structure is loaded.
Use level of detail

Specifies the default actor mesh detail to load. For example, a screw can have a lower level of detail (LOD) in a car context than in an engine context. Select one of the following:

  • Based on bounding box - The LOD is based on the size of the geometry as compared to the entire model.
  • Low
  • Medium
  • High






Low Medium High
You can define multiple LODs from Sync during the conversion process to Composer format. When opening an SMG file with LOD in the different Composer products, each actor's geometry is chosen as a function of the size of the actor compared to the full model size. Note that when resaving the file, only the current LOD is saved. Moreover, the refinement specified in Input settings is used for the higher LOD. Sub-levels are automatically defined.
Warning: If an SMG file was converted with several LODs, only the selected LOD is saved. To keep an SMG file with all LODs, change the file name (to keep the original SMG file). This does not apply to project ( .smgProj) files.

Load on visibility In loading-on-demand mode ( Home > Visibility > Visibility > Load on Visibility ), loads actor geometry when a product is not loaded and visibility is activated.

Launch

This section lets you configure launch preferences when loading a project.

Command Name Description
View mode Starts Composer applications in view mode. When you open a model, the first view (as listed in the Views pane) is displayed. To open models in animation mode at the beginning of the animation (time=0), clear this option.
Outlines on demand Calculates outlines when needed instead of when opening a file. Outline calculation takes time. Outlines are needed for some rendering modes and measurements.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Project
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS Composer 2024 SP02

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.