Hide Table of Contents

Creating and Manipulating Cutting Planes

With cutting planes, you can create and manage cross-section (cutaway) views of your models.

See Also
Cutting Planes Commands
About Cutting Planes
Using Two Cutting Planes to Create a Quarter Cross Section
  1. Click Author > Cutting Planes > Create .
    If no actors are selected, the cutting plane is applied to the entire model. The cutting plane is created normal to the positioning arrow .
    Note: You can display a maximum of three cutting planes simultaneously.
    Tip: To orient your model so the cutting plane is parallel to the screen, double-click the cutting plane.
  2. Select the plane and do either of the following:
    • To move the cutting plane to another position, click Author > Cutting Planes > Move Cutting Plane . Press Alt to align on an axis.
    • To rotate the cutting plane, move the mouse over a cutting-plane edge (the mouse pointer changes to ) and drag.
    • To change the cutting plane depth, move the mouse over the cutting plane (the mouse pointer changes to ) and drag.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Creating and Manipulating Cutting Planes
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS Composer 2024 SP02

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.