Hide Table of Contents

Using Two Cutting Planes to Create a Quarter Cross Section

Using two cutting planes, you can create a quarter cross section.

See Also
Cutting Planes Commands
About Cutting Planes
Creating and Manipulating Cutting Planes
  1. Create a cutting plane through the center of your model:
    1. Click Author > Cutting Planes > Create .
    2. In the viewport, press Alt to enable curve detection, position your mouse pointer over your model until indicates the correct position (alignment does not matter), and then click.

      Tip: You can reposition the cutting plane after creating it with Move Cutting Plane .

  2. In the Properties pane, for Axis, select the alignment you want.
  3. Click Author > Cutting Planes > Create and Add to create a second cutting plane.
  4. Click Author > Cutting Planes > Union Mode to toggle between a thin cut and a thick cut.
  5. Drag the edge of the second cutting plane to rotate to achieve a 45-degree cross section.
    Tip: To create a 90-degree cut, set the Axis property for the second cutting plane.
  6. For each cutting plane, in the Properties pane, set the Opacity to 0 and Capping > Color to the same color.
  7. If you want only some actors to be cut:
    1. Select the actors you want to cut.
    2. Click Author > Cutting Planes > Apply to Selection .


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Using Two Cutting Planes to Create a Quarter Cross Section
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS Composer 2024 SP02

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.