Hide Table of Contents

Creating Pyramids

Use the Pyramid command to create a 3D solid pyramid or a pyramid frustum. The pyramid base is parallel to the XY-plane of the coordinate system. The height is perpendicular to the base and parallel to the Z-axis.

To create a pyramid:

  1. Click Solids > Draw > Pyramid (or type Pyramid).
  2. Specify the center point of the base or enter an option:
    • Edge: Lets you define the edge of the pyramid base by specifying edge endpoints.
    • Sides: Lets you change the number of sides of the pyramid. Any whole number between 3 and 32 is valid.
  3. Specify the base radius or enter an option:
    • Inscribed: Defines the radius with an inscribed circle rather than a circumscribed circle.
  4. Specify the height or enter an option:
    • 2Point: Lets you click two points or enter their coordinates to specify the height.
    • Axis endpoint: Lets you click a point or enter the coordinates for the endpoint of the pyramid.
    • Top radius: Lets you create a pyramid frustum by defining the radius of the upper pyramid base.

Access

Command: Pyramid

Menu: Solids > Draw > Pyramid

Ribbon: 2D Drafting > Modeling > (Flyout) Pyramid
Ribbon: 2D Drafting > Mesh > (Flyout) Pyramid

Related Topics

Creating Boxes

Creating Wedges

Creating Cones

Creating Spheres

Creating Cylinders

Creating Tori

Parent Topic

Creating Solids



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Creating Pyramids
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2024 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46