Hide Table of Contents

Setting the Size of the SelectionBox

Use the SelectionBox command to define the display size of the SelectionBox (the pointer used to select entities)

To set the size of the selection box:

  1. Type SelectionBox at the command prompt.
  2. Type a height (1-50 pixels) for the SelectionBox.

  You can also set the SelectionBox size in the Options dialog box under User Preferences > Drafting Options > Entity Selection > Selections Settings.

Access

Command: SelectionBox

Related Topics

Setting the Size of the GravityBox

Specifying Drafting Options



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Setting the Size of the SelectionBox
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:
x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2024 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

10.20.4