Hide Table of Contents

Creating Arc Length Dimensions

The ArcLengthDimension command creates an arc length Dimension. It measures the distance along an Arc or Arc segment of a PolyLine.

To differentiate arc length Dimensions from linear or angular Dimensions, an arc symbol is displayed with the Dimension text.

The arc symbol is displayed before or above the Dimension text depending on the current DimensionStyle.

To create arc length Dimensions:

  1. Click Dimension > Arc Length (or type ArcLengthDimension).
  2. In the graphics area:
    1. Select an Arc or Arc segment of a PolyLine.
    2. Specify the position of the dimension line or specify an option:
      • Angle, Note, or Text: See Editing and Formatting Dimension Text.
      • Leader. Adds a Leader to the Dimension which is drawn from the dimension line to the Arc towards the center of the Arc. A Leader is added only if the included angle of the Arc is less than 90°. The command creates the Leader automatically. You must specify the location of the dimension line. The No leader option exits the Leader option and lets you conclude the command without creating a Leader.
      • Partial. Lets you dimension the length of part of an Arc. Specify two points on the Arc: one where the arc length Dimension should begin, and another where it should end. Use the EntitySnap functions to ensure that the two points are located on the Arc.

Access

Command: ArcLengthDimension

Menu: Dimension > Arc Length

Ribbon: Annotate > Dimensions > Dimension > Arc Length



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Creating Arc Length Dimensions
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2024 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.