Hide Table of Contents

Creating Baseline Dimensions

The BaselineDimension command creates a series of parallel linear Dimensions that share the same baseline. Baseline dimensioning allows you to read the cumulative Dimension between two end points extending over a number of individual Dimensions within a chain.

This type of dimensioning assumes that a related linear, angular, or ordinate Dimension exists in the drawing.

To create baseline Dimensions:

  1. Ensure that the entity you want to dimension already has a linear, angular, or ordinate Dimension to serve as the base Dimension, or insert a Dimension if necessary.
  2. Click Dimension > Baseline (or type BaselineDimension).

    When the last dimensioning command created a linear, angular, or ordinate Dimension, you are prompted to select a point as the second extension line origin. In other cases, you are prompted to select an existing linear, angular, or ordinate Dimension as the base Dimension.

    The same request appears if you press Enter to specify a second extension line origin.

  3. In the graphics area, select the:
    1. Second extension line origin or a baseline Dimension (linear, angular, or ordinate Dimension) depending on the command prompt.
    2. Points for subsequent extension line origins. Use EntitySnaps for ease of dimensioning.

      When creating linear baseline Dimensions, each Dimension displays the distance between the baseline and the point you select.

  4. If necessary, specify the Undo option to remove the last continuous Dimension created during the current command.

Access

Command: BaselineDimension

Menu: Dimension > Baseline

Ribbon: Annotate > Dimensions > (Flyout) Baseline



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Creating Baseline Dimensions
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2024 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.