Hide Table of Contents

Creating Offsets of Entities

Use the Offset command to create parallel shapes of Lines, 2D Polylines, Circles, Arcs, Ellipses, Elliptical Arcs, Splines, Rays, and InfiniteLines. A copy of a selected entity is placed at a specified distance from the original entity. The original entity stays in position.

The offset depends on the type of drawing entity:

  • Lines: Creates identical copies and moves in the direction and distance you specify.
  • Circles, Arcs, and Ellipses: Creates and scales copies using the center of the entity as a base point for scaling. You can create concentric Circles and Arcs with radii smaller or larger than the original entities.

To create offsets of entities:

  1. Click Modify > Offset (or type Offset).
  2. Type an offset distance between the source and target entity or specify an option:
    • Delete. Removes the original entity when the copy of the entity is placed.
    • Distances. Creates multiple offsets. Select an entity to offset, and click on the side of the entity to offset. Specify the first distance and second point. Then you can specify additional offsets.
    • Destination layer. Specifies whether the entity is to be copied on the active Layer or source Layer.
    • Through point. Creates an offset entity passing through a point you specify.
    • Gap type. Specifies the gap type to fill potential gaps in offset polylines:
      • Arc. Fillets gaps. The fillet radius is equal to the offset distance.
      • Chamfer. Chamfers gaps. The perpendicular distance from each chamfer to its corresponding vertex on the source linear polyline segment is equal to the offset distance.
      • Natural. Extends linear polyline segments to their projected intersections.
  3. Select the entity to offset.
  4. To reverse the previous offset without terminating the running Offset command, specify the Undo option.
  5. Specify more offsets or specify the Exit option to end the command.

 

 

Access

Command: Offset

Menu: Modify > Offset

Ribbon: Home > Modify > Offset

Tool Palettes: Modify > Offset

Related Topics

Copying Entities

Parent Topic

Modifying Entities



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Creating Offsets of Entities
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2024 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.