Name |
Specifies the outline name. |
Owner |
Specifies an owner. An Owner is not supported by all ECAD systems. The CircuitWorks software can modify the outline properties, ignoring the owner value. You can change the value before exporting IDF data:
ECAD
|
You can modify the model only in the ECAD system.
|
MCAD
|
You can modify the model only in the MCAD system.
|
Unowned
|
You can modify the model in either system.
|
|
Board Side (Only some outline types) |
Specifies where the outline is located:
|
Routing Layers (Routing outlines only) |
Specifies where the routing outline is located:
Top
|
|
Bottom
|
|
Both
|
|
Inner
|
|
All
|
|
|
Start Definition (Read-only) |
Specifies the layer where the outline begins. |
End Definition (Read-only) |
Specifies the layer where the outline ends. |
Start Height |
Specifies the height of the bottom of the outline relative to the bottom of the board. |
End Height (Group properties only) |
Specifies the height of the top of the outline relative to the bottom of the board. |
Thickness (mm) (3D outline types only) |
Specifies the outline thickness. |
Filter Status |
Filtered In
|
Specifies that the outline is included.
|
Filtered Out
|
Specifies that the outline is excluded when you build in SOLIDWORKS.
|
|