Line Properties PropertyManager - 2D Controls the following properties of a sketched 2D line. To open the Line Properties PropertyManager: In an open sketch, select a line. Existing Relations Relations Displays relations inferenced automatically during sketching or created manually with Add Relations. When you select a relation in the list, a callout is highlighted in the graphics area. Information Displays the status of the selected sketch entity (Fully Defined, Under Defined, and so on). Add Relations You can add relations to the selected entity. The list includes only relations that are possible for the selected entity. Options For construction Converts the entity to construction geometry. Infinite length Creates a line of infinite length that you can later trim. Parameters You can specify any appropriate combination of the following parameters (or Additional Parameters) to define the line if the line is not constrained by relations. When you change one or more parameters, the other parameters update automatically. Length Angle Relative to the grid, with horizontal 180°, vertical 90°, and the positive direction counterclockwise. Additional Parameters Start X Coordinate Start Y Coordinate End X Coordinate End Y Coordinate Delta X Difference between the start and end X coordinates. Delta Y Difference between the start and end Y coordinates. Parent topicSketch Entities Inferencing Add Relations/Properties PropertyManager Sketch Relations Overview Sketch Relations Callouts Sketch Geometry Status Description of Sketch Relations Sketching Lines