Hide Table of Contents
This example creates a sketch that resembles a tee shirt by inserting and mirroring sketch entities.
  1. Start DraftSight.
  2. Using the following form:
    1. Select the size of the tee shirt in Size.
    2. Specify where to place the tee shirt:
      1. Select Coordinates.
      2. Type x, y, and z coordinates.
      3. Click Insert.
        • - or -
      1. Select Point in drawing.
      2. Click Insert.
      3. Click anywhere in the drawing to insert the tee shirt at that point.

        The tee shirt is shown and zoomed to fit.
  3. Examine the drawing.


  • The width, height, and the point where the tee shirt was placed are printed to Output. Errors are also printed to Output.
  • To recreate this example:
  1. Right-click the topic and select to view the source.
  2. Save the file as an HTML file.
  3. Open the HTML file in your web browser.
  4. If using Windows Internet Explorer and running scripts is blocked, click the Information bar near the top of the webpage and select Allow Blocked Content.

    X: Y: Z:
Point in drawing



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Mirror Entities Example (JS)
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: API Help (English only) 2024 SP02

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.