Hide Table of Contents

3D Viewing Using Centered RollView

Use the RollViewCenter command to set the center of rotation for constraint orbit views and start orbit views.

For RollViewCenter, you can specify the pivot point about which you rotate the model.

To view the model in 3D using centered RollView:

  1. Do one of the following:
    • Click View > 3D Orbit > Orbit Center on the menu.
    • Click View > Render > Orbit Center on the ribbon.
    • Type RollViewCenter.
  2. In the current view, specify a center point about which you want to rotate the drawing in RollView mode.
  3. Drag the pointer to rotate the drawing in 3D, similar to the RollView command.

    During dragging, a green pivot point  appears at the center point.

  4. Optionally, press Shift to display an arcball with four small circles at each quadrant. See Using the Arcball in Rollview Mode.
  5. Press Esc or Enter to exit RollView mode.

Access

Command: RollViewCenter

Menu: View > 3D Orbit > Orbit Center

Ribbon: View > Render > (Flyout) Orbit Center

Related Topics

Using the Arcball in Rollview Mode

3D Viewing Using RollView

3D Viewing and Presentation

Parent Topic

3D Viewing Using RollView Commands



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   3D Viewing Using Centered RollView
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2024 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.21