Tolerance
Settings are in the third page of the Create Inspection
Project PropertyManager. In Tolerance Settings, you
specify tolerance types, units, and formatting.
Type
By
Precision |
Specifies the default tolerances by
precision (based on the number of decimal places in nominal
dimensions). In
the Format table, enter tolerances for a
dimension with zero decimal places on line 0, with one decimal
place on line 1, and so on.
|
By
Range |
Specifies the default tolerances
by a range of values. Enter the lower and upper
limits for each range for the nominal value in the Format table and enter the
default tolerance for that range.
|
Units
Specifies the unit of measure.
Format
Specifies the Linear and Angular plus and
minus tolerance values for linear and angular dimensions.