Allows access to the ICOSMOSWorks interface. 

Allows access to the uniform or selected excitation used in dynamic studies.

Allows access to beams and trusses.

Allows access to beams, trusses, and joints.

Allows access to bearing loads that develop between contacting cylindrical faces.

Allows access to a bolt connector.

Allows access to the options of a buckling study. 

Allows access to the centrifugal force object used for structural studies. 

Allows access to the options for composite shells.

Allows access to component contacts.  

Allows managing of global contacts, component contacts, and contact sets.  

Allows access to a contact set. 

Allows access to convection used for steady state and transient thermal studies only.

Allows access to the damping options in dynamic studies.

Allows access to the distributed mass used in structural studies.

Allows access to the options for the output of the drop test analysis.

Allows access to the setup of a drop test study.

Allows access to the options of a drop test study.

Allows access to the initial (time = 0) condition for displacements, velocities, or accelerations in modal time history and nonlinear dynamic studies.

Allows access to the options of a dynamic study.

Allows access to an edge weld connector.

Allows access to an elastic support fixture.

Allows access to a fatigue event.

Allows access to the options of a fatigue study.

Allows access to the force object used by structural studies.  

Allows access to the options of a frequency study.

Allows access to the gravity load used in structural and nonlinear analyses.

Allows access to the heat flux object used for steady state and transient thermal studies only.

Allows access to heat power used for steady state and transient thermal studies only.

Allows access to the joints, which are the intersections of beams, in a model.

Allows access to a link connector.

Allows access to the Load Case Manager.

Allows access to an existing load or restraint in a study.

Allows access to managing loads and restraints.

Allows access to the mass properties of a study.

Allows access to the material; certain materials are required for every study type.

Allows access to a mesh.

Allows access to a mesh control.

Allows access to the active part or assembly document.

Allows simultaneous editing of multiple component contacts.

Allows simultaneous editing of multiple contact sets.

Allows access to the options of a nonlinear study.

Allows access to a pin connector.

Allows access to a results plot.

Allows access to pressure used for structural studies.

Allows access to the radiation object used for steady state and transient thermal studies only.

Allows access to remote loads.

Allows access to displacement restraints for structural studies.

Allows access to the results of the analysis.

Allows access to the results probe of a plot.

Allows access to a rigid connector.

Allows access to the run and mesh option for studies run in batch mode.

Allows access to the results of studies run in batch mode.

Allows access to an existing shell.

Allows access to shells.

Allows access to solid bodies in a study.

Allows access to solid components in a study.

Allows access to managing solid bodies and components.

Allows access to a spot-weld connector.

Allows access to a spring connector.

Allows access to the options of a static study.

Allows access to a study.

Allows access to creating new studies and getting or deleting existing studies.

Allows access to the options for the results of linear dynamic and nonlinear studies.

Allows access to the temperature for use with structural (static, nonlinear, buckling, and frequency), steady state, and transient thermal studies.

Allows access to the options of a thermal study.

Allows access to the Trend Tracker of a static study.