You can specify the origin or destination of
cables from:
- SOLIDWORKS Electrical menu: Set
Origin / Destination of Cables
.
- In the menu, click
.
Options for
Set Origin / Destination of
Cables include:
Select
cable to route
Lets you select an electrical project cable.
Select
Origin/Destination components (electrical component, cable gland...)
There are two selection zones. The
first selection zone lets you specify the component connected to the cable origin.
The second selection zone lets you specify the component connected to the cable destination.
- Select cable Origin
component. Specifies the component that the first end of the
cable connects to in the graphics area.
- Select cable Destination
component. Specifies the component that the second end of
the cable connected to in the graphics area.
The origin and destination assemblies on which the cable is connected must
have connection points (EwCable - see
Electrical Components Wizard).
Existing Origin / Destination
components
for cable
When you select a cable, this zone displays the list of components
connected to the cable. This information comes from the electrical project database.
You must manage each cable individually.