Treat coincidence as interference |
Reports coincident entities as
interferences. Not
available in Large Design Review
mode.
|
Show ignored interferences |
Displays ignored interferences
in the Results list, with
a gray icon. |
Treat subassemblies as components |
Views subassemblies as single
components so interferences between a subassembly's components
are not reported. |
Include multibody part interferences |
Reports interferences between
bodies within multibody parts. |
Include surface bodies |
Reports interferences between surface bodies. Surface
interferences appear at the end of the results list. The volume of interference is not available
for surface body
interferences.
Not
available in Large Design Review
mode.
|
Make interfering parts transparent |
Displays the components of the
selected interference in transparent mode. |
Create fasteners folder |
Under Results,
segregates interferences between fasteners (such as a nut and
bolt) into a separate folder named Fasteners. See Interference Detection with Fasteners. Not
available in Large Design Review
mode.
|
Create matching cosmetic threads folder |
Under Results, segregates interferences between
components with properly matched cosmetic threads into a
separate folder named Matching
cosmetic threads. Interferences because of mismatched threads, misaligned
threads, or other interfering geometry are listed as
interferences.
Not
available in Large Design Review
mode.
|
Ignore hidden bodies/components |
Excludes the following interferences from the results:
- Interferences involving components that
are hidden, including those hidden by the Isolate command.
- Interferences between a multibody
part's hidden bodies and other components.
Not
available in Large Design Review
mode.
|