Hide Table of Contents
GetWorstJacobianRatio Method (ICWMesh)

Gets the worst Jacobian ratio for this mesh.

.NET Syntax

Visual Basic (Declaration) 
Function GetWorstJacobianRatio() As System.Double
Visual Basic (Usage) 
Dim instance As ICWMesh
Dim value As System.Double
 
value = instance.GetWorstJacobianRatio()
C# 
System.double GetWorstJacobianRatio()
C++/CLI 
System.double GetWorstJacobianRatio();

Return Value

Worst Jacobian ratio (see Remarks)

Example

Remarks

The data returned by this method is valid only if ICWMesh::Quality is set to swsMeshQuality_e.swsMeshQualityHigh.

Analysis of curved geometry requires a mesh of parabolic tetrahedral elements. With extremely curved edges, placement of the mid-side nodes of these elements on the geometry can distort the elements and the analysis.

The Jacobian ratio calculated at a point inside a parabolic mesh element provides a measure of the degree of distortion at that location. The higher the ratio, the greater the distortion of the element. A Jacobian ratio of 40 or less is acceptable. A negative Jacobian ratio causes SOLIDWORKS analysis to stop.

Call this method after ICWStudy::CreateMesh to calculate the worst or highest Jacobian ratio among the elements of this mesh.

See the SOLIDWORKS Simulation Help for more information about Jacobian ratios and meshes.

 

See Also

Availability

SOLIDWORKS Simulation API 2012 SP0


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   GetWorstJacobianRatio Method (ICWMesh)
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: API Help (English only) 2025 SP04

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.49