Hide Table of Contents
NegativeJacobianRatioCheck Property (ICWMesh)

Obsolete. Superseded by ICWMesh::NegativeJacobianRatioCheck2.

.NET Syntax

Visual Basic (Declaration) 
Property NegativeJacobianRatioCheck As System.Integer
Visual Basic (Usage) 
Dim instance As ICWMesh
Dim value As System.Integer
 
instance.NegativeJacobianRatioCheck = value
 
value = instance.NegativeJacobianRatioCheck
C# 
System.int NegativeJacobianRatioCheck {get; set;}
C++/CLI 
property System.int NegativeJacobianRatioCheck {
   System.int get();
   void set ( &   System.int value);
}

Property Value

1 to check for a negative Jacobian ratio, 0 to not

Remarks

For more information, read the Jacobian Points section of the Simulation > Meshing > Mesh Quality Checks topic in the SOLIDWORKS help.

See Also

Availability

SOLIDWORKS Simulation API 2020 SP0


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   NegativeJacobianRatioCheck Property (ICWMesh)
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: API Help (English only) 2025 SP04

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.10