> Advanced Techniques > 3D Sketching with Planes > Adding and Dimensioning a Line

SOLIDWORKS Connected Tutorials

Sample Files

SOLIDWORKS Connected and the 3DEXPERIENCE Platform

Advanced Design Techniques

Advanced Drawings Overview

Assembly Visualization

Sketch Blocks

3D Sketching

3D Sketching with Planes

Approaches to 3D Sketching

Sketching on 3D Sketch Planes

Adding and Dimensioning a Line

Adding Tangent Arcs

Using References

Displaying 3D Sketch Properties

Adding Relations Between 3D Sketch Planes

Preparing to Create Splines

Creating the First Splines

Redefining the Splines

Adding Curvature to Splines

Completing the Addition of Curvature

Sketching Construction Lines

Fully Defining the Geometry

Creating the Third Spline

Completing the Third Spline

Creating the Loft

Multibody Parts

Molds Design Introduction

Molded Product Design - Advanced

Electrical Routing

Routing - Pipes and Tubes

Productivity Tools

Design Evaluation

Adding and Dimensioning a Line

Sketch an equal, vertical construction line to the left of the first.

As you sketch, use sketch snaps to guide you so that relations are added by inference.

Click this animation to play it or to reset it.
Click Line (Sketch toolbar), and sketch two horizontal lines connecting the end points of the construction lines.
Click Smart Dimension (Dimensions/Relations toolbar), dimension one of the lines to 75, then click .

Search 'Adding and Dimensioning a Line' in the SOLIDWORKS Knowledge Base.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required


*Email:
Subject:		Feedback on Help Topics
Page:		Adding and Dimensioning a Line
*Comment:
*		I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Cancel

Print Topic

Select the scope of content to print:

This topic and all topics linked from this topic

Just this topic

This topic and only immediate topics under it

This selected topic and all subtopics

Cancel

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

Never show this message again

Web Help Content Version: SOLIDWORKS Connected Tutorials (3DEXPERIENCE SOLIDWORKS) 2025 SP2

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.