Creating a Broken Out Section View

Now that you have a projected view, you can create a broken-out section view.

1. Click Broken-out Section (Drawing tab).
2. Sketch a spline approximately as shown. The spline that you sketch designates the boundaries of the broken-out section view.
   When you sketch a spline, the spline points snap to geometry. To temporarily turn off snapping, hold down Ctrl as you sketch the spline. Release Ctrl when you want to connect the beginning and end of the spline.

   

3. In the graphics area, select the edge of the hole as shown in Drawing View1 for Depth Reference . The broken-out section view will be up to the depth of the selected hole.
   
4. Click .