> Advanced Techniques > 3D Sketching > Dimensioning the Sketch and Adding Fillets

SOLIDWORKS Connected Tutorials

Sample Files

SOLIDWORKS Connected and the 3DEXPERIENCE Platform

Advanced Design Techniques

Advanced Drawings Overview

Assembly Visualization

Sketch Blocks

3D Sketching

Using a 3D Sketch to Create an Oven Rack Frame

Sketching the Rest of the Lines

Dimensioning the Sketch and Adding Fillets

Using Sweep to Complete the Feature

Extruding the Supports

Patterning the Extrusion

Mirroring All

3D Sketching with Planes

Multibody Parts

Molds Design Introduction

Molded Product Design - Advanced

Electrical Routing

Routing - Pipes and Tubes

Productivity Tools

Design Evaluation

Dimensioning the Sketch and Adding Fillets

Dimension the sketch as shown.
Click Sketch Fillet (Sketch toolbar), and fillet each intersection with a 5mm fillet.
To fillet the intersections, select the point where two lines meet.
Click 3D Sketch (Sketch toolbar) or Insert > 3D Sketch to close the sketch.
Click File > Save to This PC.
In the dialog box, for File name, enter rack and click Save.

Search 'Dimensioning the Sketch and Adding Fillets' in the SOLIDWORKS Knowledge Base.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required


*Email:
Subject:		Feedback on Help Topics
Page:		Dimensioning the Sketch and Adding Fillets
*Comment:
*		I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Cancel

Print Topic

Select the scope of content to print:

This topic and all topics linked from this topic

Just this topic

This topic and only immediate topics under it

This selected topic and all subtopics

Cancel

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

Never show this message again

Web Help Content Version: SOLIDWORKS Connected Tutorials (3DEXPERIENCE SOLIDWORKS) 2025 SP2

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.