Editing Smart Components

  1. Open bearing.SLDPRT.
  2. In the FeatureManager design tree, right-click Smart Feature , and click Edit in Defining Assembly.
    A temporary assembly bearing_ta.SLDASM opens.

  3. Click Edit Definition on the pop-up toolbar.
  4. In the PropertyManager, click Configurator Table.
  5. For bearing configuration NPD-28, change the screws and lock washers as highlighted in the table below. Do not change the flat washers.


  6. Click OK, then click .
  7. On the ConfigurationManager tab, double-click NPD-28 to see the updated configuration.
  8. Click File > Save to This PC and close the assembly.
    Click Save All if prompted.
    The temporary assembly disappears. The updated defining data is saved in the component document bearing.SLDPRT.

Congratulations! You have completed this tutorial.