Placing Dimensions

Place some dimensions on the drawing.

  1. Click Options on the Standard toolbar.
  2. On the Document Properties tab, select Units and in Unit system, select MMGS, then click OK.
  3. Click Smart Dimension on the Annotation tab.
  4. Move the pointer to the edge of the outer circle of the ring (top view) and click.
  5. Move the pointer to place the dimension and click.
    The diameter dimension 128 appears.
    Under Tolerance/Precision, make sure Unit Precision is set to None, so that decimal places do not appear on the dimension.
  6. Add three other diameter dimensions as shown:
    1. Select the edge of each circle.
    2. Move the pointer to place the dimensions and click.