Recreating the Face Fillets

To recreate the face fillets you removed, you add a Fillet feature before the Shell1 feature. If you add it after the Shell feature, the filleted area is not shelled.

  1. In the FeatureManager design tree, place the pointer over the rollback bar below the Shell1 feature.
    The pointer changes to a hand:

  2. Drag the rollback bar above the Shell1 feature.
  3. Click Fillet (Features tab).
  4. Select the front face of the base.
    The model shows the last radius used, 10mm.

  5. Under Fillet Parameters, change the Radius to 5.
  6. Click .
  7. Drag the rollback bar below the Shell1 feature.