Completing the Part

The final step is to create a cut to hold a candle.

1. Select the top face of the revolved base feature, then click Extruded Cut on the Features tab.
2. Click Circle on the Sketch tab, and select the sketch origin. Sketch and dimension a circle as shown.
   
   
   
3. Click Exit Sketch on the Sketch tab.
   The Cut-Extrude PropertyManager opens.
4. Click Isometric (Heads-up View toolbar).
5. In the PropertyManager, under Direction 1:
   1. Select Blind in End Condition.
      Click Reverse Direction if necessary to make the arrow point down.
      
   2. Set Depth to 25.
   3. Click Draft On/Off , and set Draft Angle to 15.
6. Click .
   The cut is added to the top of the candlestick.