Tab and Slot PropertyManager

Spacing

  Center Align Places the tabs from the center of the intersecting edge.

Specify the Number of Instances and Spacing to define the number of instances based on the distance.

Offset

Tab Start Reference Specifies the point, vertex, or edge where the offset begins.
Tab End Reference Specifies the point, vertex, or edge where the offset ends.
  Equal Offset Creates an offset where the start and end distance is the same from the reference points.

Tabs

Tab Direction (Non-sheet metal parts only.) Creates the tab in a direction other than normal to the tab face based on your selection in the graphics area.

You can select points, planes, edges, axes, vertices, linear sketch entities, or planar faces.

Instances to Skip

Instances to Skip Skips the tab and slot instances that you select in the graphics area.

In the graphics area, pink selection orbs display on the tab and slot instances. The pointer changes to when you hover over each instance and the coordinates of the instance appear. Click a selection orb.

To restore a skipped instance, click the selection orb again.