Edge Flange PropertyManager
You can add edge
flanges to one or more edges.
Flange Parameters
Edge 
. Select
edges in the graphics area.
To merge bodies in a multibody sheet metal
part, select only one edge.
Edit
Flange Profile. Edit the sketch
of the profile.
Use default radius.
Select or clear.
Use gauge table.
(Only available
if a sheet metal gauge table has been selected for the part) Select or
clear.
Bend Radius 
.
Set a value when Use default radius
and Use gauge table are cleared.
Gap distance
. Set a value.
Angle
Flange Angle 
.
Set a value.
If you select Up to Edge and Merge
for Flange Length, the angle is
locked. Click 
to unlock the angle and change it.
Select face 
.
Select a face to set the parallel or perpendicular relation for the Flange Angle.
Perpendicular to face. Sets
the edge flange perpendicular to the face in Select
face.
Parallel to face. Sets the edge
flange parallel to the face in Select
face.
Flange Length
Length End Condition.
A virtual
sharp creates a sketch point at the virtual intersection point
of two sketch entities.
Up
to Vertex. Creates the edge flange up to a vertex you select in
the graphics area.
Vertex
Up to Edge and Merge. In a multibody part, merges the selected
edge with a parallel edge in another body.
Outer Virtual Sharp
, Inner Virtual
Sharp 
. Specifies the
origin for the measurement.
Select an up to
reference edge .
Flange Position
Bend Position:
Select one of the following:
Trim side bends. Select to remove extra material.
Offset.
Select to offset the flange.
Offset End Condition.
Select an item for Offset
End Condition.
Reverse Direction 
.
Change the direction of the offset.
Offset Distance 
. Set a value.
Custom Bend Allowance
Select
to set a Bend Allowance Type
and a value for the bend allowance.
Custom Relief Type
Select a
to add
relief cuts, then select the type of relief cut.