Hide Table of Contents

Geometry Analysis Results

After the analysis operation is complete, the Analysis Results section in the PropertyManager appears.

Under Analysis Results:

  • The results are shown in a tree view.

  • Each type of geometry appears as a node in the tree view. Under each item, the entities that satisfy the analysis criteria are listed. Items are listed in ascending order:

    • Short edges - by edge length

    • Small faces - by face area

    • Sliver faces - by face area

    • Knife edges - by angle between faces

    • Knife vertices - by angle between edges

  • Click individual items (nodes) in the tree view to highlight the corresponding entities in the graphics area. To help you locate an entity, a callout is displayed in the graphics area. The corresponding value for the entity is displayed next to the item in the results tree.

  • Click Save Report to save the analysis results in HTML format.

  • Click Recalculate to clear the results and prepare for another calculation.

You can access the saved report at any time using the SolidWorks Utilities Report Manager.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Geometry Analysis Results
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2010 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.48