Hide Table of Contents

Equation Comments

  • You can add comments to equations to document your design intent. Place a single quote (‘) at the end of the equation, then enter the comment. Anything after the single quote is ignored when the equation is evaluated. Example:

    "D2@Sketch1" = "D1@Sketch1" / 2 ‘ height is 1/2 width

  • You can also use comment syntax to prevent an equation from being evaluated. Place a single quote (‘) at the beginning of the equation. The equation is then interpreted as a comment, and it is ignored.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Equation Comments
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2011 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.26